1. Name
      Please enter your name (characters only)
    2. Phone Number (###-###-####)
      Please enter a valid phone number (###-###-####)
    3. E-mail Address
      Please enter a valid e-mail address
    4. Your Question
      Don't forget to ask your question!

Q

u

e

s

t

i

o

n

s

?

Jetfoam™ (5 gallon pail)

Jetfoam™ (5 gallon pail)
Brand: EnviroServe Corporation
Product Code: JetFoam - 5gal
Availability: In Stock
Price: $175.00
Qty:  
   - OR -   

When the sewer jet was introduced in the 1950's, it was a revolution in sewer cleaning. By replacing both machine and hand fed rodding equipment, sewer jets provide a better and faster way for clearing grease blockages and for routine cleaning.

Over the years, the sewer jet has remained basically the same even though water volume and PSI have increased. Now, Jetfoam™ can double the speed and effectiveness of your sewer jet for as little as 4 cents per foot.

Jetfoam™ liquifies the grease and keeps it in suspension. It dramatically improves your jet’s speed and effectiveness in treating grease problems.

Jetfoam™ cleans by using the following principles:

  1. Physical removal
  2. Mixing action
  3. Earth-friendly emulsification
  4. Prevents grease recoagulation

 

  • Less Expensive: Saves money on labor and equipment wear
  • Faster: Frees the crew for other work
  • More Efficient: Cleans at least twice as much sewer line in the same amount of time
  • More Thorough Cleaning: Reduces frequence of cleanings
  • Saves Time: One pass will normally clean the sewer line
  • Safer: Requires less time on hot spot lines in high traffic areas

Mixing Instructions

  • Always follow label directions
  • Use proper protection
  1. Jetfoam™ should not be used in temperatures belows 40ºF
  2. Proper mixing is very important.  For best mixing results, use the jet's recirculator system for 10 - 15 minutes or:
    1. ​Fill half the tank with water
    2. Add Jetfoam™ (mix 5 gallons of Jetfoam™ for every 500 gallons of water in the jet's tank)
    3. Complete filling the tank
  3. ​Each 5 gallon pail of Jetfoam™ (or 500 gallons of Jetfoam™ solution) will treat approximately 500 feet of line up to 10 inches in diameter.

Sewer Line Cleaning

  1. Direct solution up sewer line at high pressure and half volume between
  2. When solution reaches second manole, shut down equipment and allow approximately 10 minutes for product to penetrate and lift grease.
    (Wait an additional 5-10 minutes to allow further penetration if grease accumulation is old and hard)
  3. Spray back to original manhole at high pressure and volume
  4. One pass through sewer lines is usually all that is required
  5. Flush the line with clean water to remove remaining debris

Manholes, Wet Wells and Lift Stations

  1. Using the jet truck, spray a direct stream of the Jetfoam™ solution onto the grease for 10 minutes
  2. After stopping the spraying, wait 10 minutes to allow penetration
  3. Blast the grease with high volume and high pressure regular water
  • Avoid direct skin and eye contact
    In the event of direct skin or eye contact, flush affected area with water.  If irritation persists, contact a physician

 

Non-hazardous • Environmentally Friendly • No Petroleum Distillates • No Butyl • Non-corrosive

 

No VOCs • Neutral pH • Non-flammable • Aqueous Based

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: